Sectional Garage Door Repairs in Craigieburn

It depends on which part has failed and whether it is a single or double door, because swapping a set of rollers is a very different job to replacing a torsion spring, a cable drum or a damaged panel. We do not quote sectional doors blind over the phone, because the real fault is usually only clear once the door is disconnected from the opener and cycled by hand. We inspect on site, show you exactly what has failed, and give you one fixed price before any work begins, with no call-out games and no figure that changes on the driveway. Call Ontime on 0406 723 086.

Usually, yes. We are based in Craigieburn and work right across Melbourne's northern suburbs, and we answer the phone seven days a week from 7am to 9pm, so most local repairs are booked and completed the same day you call. We carry the common springs, cables, rollers and opener parts on the van, which is what lets us finish the large majority of jobs in one visit. If your door is stuck open and you cannot secure the garage, tell us when you call and we will prioritise getting to you.

A broken torsion spring leaves the full weight of the door on the cables and the opener, and the spring itself is still holding some tension, so it is not a part to touch or attempt to wind yourself. Stop using the door, do not try to force it open with the opener because that can damage the cables, drums and opener gear, and give us a call. We replace springs with the correct wire size, length and wind direction for your door's weight, wind them to the right turns with proper winding bars, and rebalance the door afterwards, which is exactly what keeps the repair both safe and lasting.

It depends where the damage is and how deep it runs. A shallow dent that does not stop the panel passing the rollers can often be left alone or gently straightened, but a cracked, creased or badly bent panel usually binds as the door travels and is better replaced. We match the replacement panel to your door's profile and colour where we can, and if the door is an older or discontinued profile we will tell you honestly what is still available and what your options are before you commit to anything.

A door that lifts crooked or sits lopsided in the opening almost always points to a cable or drum fault on one side, or a torsion spring that has lost tension. Continuing to run the opener against it makes the problem worse and can pull the door fully off its track, turning a modest repair into a much larger one, so stop operating it and give us a call. We renew the cables as a matched pair and reset the drums so the door pulls evenly on both sides and sits square in the frame again.

Yes. We repair the sectional and panel-lift doors fitted by all the major brands used across Melbourne's north, including B&D, Steel-Line, Gliderol and Colorbond panel doors, on single and double garages, from modern insulated panels to older steel and timber sectionals. We carry the common springs, cables, rollers, hinges and opener parts on the van, so most makes and models are diagnosed and repaired in a single visit rather than a return trip.